WORKSHOP MANUAL
MPV 320W / 520W
4. In different values are detected, loosen the
nut (8) and turn the handle (9) screwing or
unscrewing it on the bolt (10) until the correct
value is reached.
5. When the adjustment has been made, tighten
the nut (8).
NOTE If the correct value cannot be reached, it
is necessary to adjust the spring (6) nut (4) again.
6.2.4 Replacing and adjusting the blade connection belt
• Follow all steps of the "Removing the cutting deck" procedure
1. Release the four split pins (1) and remove the
pivot arm carriage (2).
2. Remove the protective cover (3) fixed by the
five screws (4).
4
6 - CUTTING DECK AND COLLECTION
3
4
4
Chapter
[
6.1.3].
1
1
EDITION
PAGE
2017
39 /
64
8
9
10
2
1
1
3
4
4