Removal Of The Cutting Deck - Stiga MPV 320W Workshop Manual

WORKSHOP MANUAL
MPV 320W / 520W
To return the cutting deck to the working position, follow the above op-
erations in the reverse order, taking care to properly reinstate the belt (2)
around the clutch pulley (3), the clutch pulley (4) and the tensioner (5 ),
according to the diagram indicated below.
1

6.1.3 Removal of the cutting deck

• Place the machine on a flat, solid surface, wide enough to allow the extraction of the cutting
deck from the front.
• Follow steps 1 to 2 of the "Verticalisation of the cutting deck" procedure
1. Release the two rear split pins (1) from the left and right sides and remove the respective pins
(2).
2. Rotate the levers (3) forwards to the right and to the left to unlock and disengage the respective
pivot arms (4) from the forks (5).
3. Grasp the cutting deck (6) using the handles
and pull it forward by releasing the arms (4)
from the fork (5).
WARNING!
release of the arms causes the sudden
movement of the two forks upwards.
Maintain the due distance from the forks
and make sure no other people access the
area during the extraction of the cutting
deck.
4
6 - CUTTING DECK AND COLLECTION
Remember to reinstate the belt tension moving the
tensioner lever (1) to the forward position.
- Make sure that the
3
Chapter
5
EDITION
2017
4
[ 6.1.2].
1
5
PAGE
35 /
64
2
5
3
2
4
6