Cutting Deck And Collection - Stiga MPV 320W Workshop Manual

WORKSHOP MANUAL
MPV 320W / 520W
2. Free the belt (2) from the three clutch (3), drive
(4) and tensioner (5) pulleys, leaving it around
the cutting deck pulley (6) only.
3. Remove the two rear split pins (7) from the left
and right sides and remove the respective pins (8) from the lifting fork holes (9).
4. Reposition the same pins (8) in the rear holes (10) of the sliding carriage and replace the rela-
tive split pins (7).
5. Remove the two front split pins (11) from the left and right sides and remove the respective pins
(12) to allow the carriage to slide on the guides.
7
6. Align the two front wheels.
7. Grasp the two handles (13) and pull the cutting deck (14) forwards as far as possible.
8. Using the same handles, move the cutting deck (14) into a vertical position.
WARNING!
cure the cutting deck to
a bearing structure of
the machine in order to
prevent it from acciden-
tally falling and causing
injury or damage during
maintenance.

6 - CUTTING DECK AND COLLECTION

8
7
9
14
- Se-
13
Chapter
3
5
10
8
13
EDITION
2017
2
4
6
11
12
14
PAGE
34 /
64