Stiga MPV 320W Workshop Manual page 27

WORKSHOP MANUAL
MPV 320W / 520W
2. Release the parking brake spring (2).
3. Unhook the split pin (3) and disconnect the
head (4) of the drive control cable.
4. Remove the by-pass control rod (4), connect-
ed to the transmission unit lever by the pin (5)
and the spring (6).
5. The hydrostatic unit (7) is fastened to each
side of the chassis by means of three screws
(8) with relative (9). Carefully unscrew the low-
er nuts (9), adequately supporting the unit so
it does not fall.
When reassembling, perform the operations de-
scribed above in the reverse order.
• Tighten the nuts (9) with a torque of 23-27 Nm.
When assembly is complete,
• Check the parking brake works properly
• Adjust the transmission cable
5 - TRANSMISSION - WHEELS - STEERING
[ 5.1.4].
[ 5.1.5].
Chapter
3
4
8
9
EDITION PAGE
2017 27 /
2
5
6
8
9
7
64
4