Maintenance; Criteria For Maintenance; Routine Maintenance Schedules - Stiga MPV 320W Workshop Manual

WORKSHOP MANUAL
MPV 320W / 520W

2.4.1 Criteria for maintenance

The Instruction Handbook has a number of operations to be carried out by the Customer for a
minimum of basic maintenance, and other operations not always within his capacity. For this rea-
son the Service Centre should undertake to keep the machine in perfect working order adopting
a routine maintenance schedule.

2.4.2 Routine maintenance schedules

The routine maintenance schedule includes a series of interventions, at the intervals indicated in
the table below:
INTERVAL
Every 25 hours
or
seasonally
Every 50 hours
or
seasonally
After the first 75 hours
of operations
Every 400 hours
2 - SERVICING RECOMMENDATIONS

2.4 MAINTENANCE

OPERATION
Check the safety systems
Cleaning the machine
Check and sharpen the
cutting deck blades
Check the tyre pressures See the technical specifications
Check the tension of the
transmission belts
Check the tightness of
the wheel bolts
Lubrication
Interventions on the
hydrostatic transmission
unit
Interventions on the
hydrostatic transmission
unit
Chapter
DANGER! Failure of the safety lock system
and incorrect operation of the machine can result in
death or serious injury.
Check that the safety systems are working correctly as in-
dicated. [ 7.1.2]
Clean the machine (seat, cutting deck, etc. removing all
dirt and debris). Do not use high pressure washers, sol-
vents, aggressive detergents or abrasive cleaners. Re-
store damaged paint using STIGA paint
Check that the blades are not worn or damaged. Sharpen
and balance the blades.
Adjust the upper belt spring
Adjust the lower belt spring
Tighten the screws to the prescribed values
1) PTO belt
tensioner
greaser
1) Oil change [ 5.1.6 a]
2) Oil filter replacement
3) Bleeding of the hydraulic circuit
1) Oil change [ 5.1.6 a]
2) Oil filter replacement
3) Bleeding of the hydraulic circuit
EDITION
2017
ACTION
[ 6.2.1]
[ 3.1]
[ 5.1.1]
[ 5.1.2]
[
2) Forward
drive pedal
support
greaser
1
[ 5.1.6 b]
[ 5.1.6c]
[ 5.1.6 b]
[ 5.1.6 c]
PAGE
11 /
64
5.2.2]
2