Replacement And Repair Of Tyres - Stiga MPV 320W Workshop Manual

WORKSHOP MANUAL
MPV 320W / 520W
1. Remove each bearing (1) using a 10 - 12 mm
diameter round bar (2); insert it from the op-
posite side and hammer it on various points
around the internal circumference of the bear-
ing.
2. The new bearing must be inserted with the
help of a plastic mallet or a bronze buffer (3)
working only on the outer ring of the bearing.
IMPORTANT We recommend you always re-
place both hub bearings.

5.2.4 Replacement and repair of tyres

The tyres used on this machine are of the «Tubeless» type and so every repair of a hole in the tyre
must be done by a tyre specialist according to the methods used for this type of tyre.
IMPORTANT The rear tires can have different rolling diameters, due to wear or after replacement
of one of the two. These differences must never be offset by varying the inflation pressure, which
must ALWAYS be the same for both.
After the replacement of one or both tyres, it is always necessary to:
• Check the inflation pressure
5 - TRANSMISSION - WHEELS - STEERING
[ 3.1].
Chapter
2
3
EDITION PAGE
2017 29 /
64
1
1
1