Wheels And Tyres; Removing And Replacing The Rear Wheels; Replacing The Front Wheels; Replacing The Rear Wheel Bearings - Stiga MPV 320W Workshop Manual

WORKSHOP MANUAL
MPV 320W / 520W

5.2.1 Removing and replacing the rear wheels

• Lift the rear part of the machine
The rear wheels (1) are held by a snap ring (2)
which can be removed with a screwdriver after
removing the cap (3).
NOTE If a wheel is jammed onto the shaft, use a
release spray directing it around the press-fitting
hole.
WARNING!
rims as they could impair the hold of the tyre.
On assembly it is advisable to spread grease on
the shaft to facilitate the next wheel removal.

5.2.2 Replacing the front wheels

• Lift the front part of the machine
The front wheel (1) is fixed by four screws (2).
WARNING!
rims as they could impair the hold of the tyre.
When replacing, tighten the screws (2) to a torque
of 89-93 Nm.

5.2.3 Replacing the rear wheel bearings

• Remove the wheel in question
The front wheel bearings are force shrink-fitted into the front wheel hub.
5 - TRANSMISSION - WHEELS - STEERING

5.2 WHEELS AND TYRES

[ 2.3.3].
- ALWAYS replace deformed
[
- ALWAYS replace deformed
[ 5.2.1].
Chapter
1
1
2.3.2].
EDITION PAGE
2017 28 /
64
2
2
2
2
2
3