Indications; Indications During Commissioning; Indications In The Display - AUMA SQ 05.2 Operation Instructions Manual

SQ 05.2 SQ 14.2/SQR 05.2
AC 01.2 Intrusive Profinet
8.

Indications

8.1.

Indications during commissioning

LED test
Language selection
Startup menu
8.2.

Indications in the display

SQR 14.2 Control unit - electromechanical
When switching on the power supply, all LEDs on the local controls illuminate for
approx. 1 second. This optical feedback indicates that the voltage supply is connected
to the controls and all LEDs are operable.
Figure 38: LED test
During the self-test, the language selection can be activated so that the selected
language is immediately indicated in the display. For this, set selector switch to
position 0 (OFF).
Activate language selection:
1. Display indicates in the bottom line: Language selection menu? 'Reset'
2. Hold down push button RESET until display of the following text in the bottom
line: Language menu loading, please wait.
Figure 39: Self-test
The language selection menu follows the startup menu.
The current firmware version is displayed during the startup procedure:
Figure 40: Startup menu with firmware version: 05.00.00 xxxx
If the language selection feature has been activated during the self-test, the menu
for selecting the display language will now be indicated. For further information on
language setting, please refer to chapter <Language in the display>.
Figure 41: Language selection
If no entry is made over a longer period of time (approx. 1 minute), the display
automatically returns to the first status indication.
Menus and functions depend on the actuator controls firmware version!
Should menus or functions be unavailable, please contact the AUMA Service.
Indications
43