Description Profibus Dp Interface; Status Indications In The Display - AUMA AUMATIC AC 01.1 Short Instructions

Short instructions
5.

Description Profibus DP interface

LED 'SYSTEM OK'
LED 'DATA EX' (V2)
LED 'CAN STATE' (V3)
LED 'STATE' (V4)
5.1 Status indications in the
display
Figure P: Profibus DP interface
X2
SYSTEM OK (V1)
DATA EX (V2)
CAN STATE (V3)
STATE (V4)
Table 6: DIP switch S1: Configuration of the Profibus DP board
S1-1
S1-2
This LED shows the correct voltage supply to the Profibus DP board.
(V1)(green)
Is continuously illuminated: Voltage connected to Profibus DP interface.
Is blinking:
Is not illuminated:
When LED is illuminated, the Profibus DP interface has entered 'Data
Exchange' state. Only in this state can the actuator be controlled by the
(green)
Profibus DP master and the state of actuator be read.
Is illuminated or blinking:
Is not illuminated:
(red)
Is illuminated or not illuminated:
is blinking:
(green)
Regular blinking of the LED during operation indicates correct operation of
the Profibus DP interface.
The status indications (Group
mode as well as faults and warnings. For detailed notes regarding the
indication and operation see the appropriate operation instructions of the
actuator.
Actuator controls AUMATIC AC 01.1 / ACExC 01.1
C
Only one Profibus DP interface
available
Two Profibus DP interfaces avail-
able
Spare
Microcontroller defective.
No voltage at the DP interface.
S ) in the display show the current operation
OFF
1 st Profibus DP interface: OFF
2 nd Profibus DP interface: ON
OFF
Communication to logic is faulty
Communication with logic is o.k.
Profibus DP interface is not ready
Program on the Profibus DP interface is
being executed.
Profibus DP
X4
V16
V19
V22
V25
S1
13