Section 9: Addendum For Base Card Fw 7.00; Multiple Functionality Of Esd Command And Status - Emerson Bettis XTE3000 Installation, Operation And Maintenance Manual

Installation, Operation and Maintenance Manual
MDE 255 Rev. 0

Section 9: Addendum for Base Card FW 7.00

This addendum explains some functionality introduced with base card Firmware version 7.00.
The revision of base card can be checked with parameter 56 "SW_VERSION" of Resource Block.
If revision of base card is less than 7.00, this addendum is not relevant.
9.1 Multiple Functionality of ESD
Command and Status
The ESD command and status issued with channel 53 and 18 can assume the meaning of PST signal,
based on type of actuator and setting of "ESD INPUT MODE" parameter.
Table 41 below lists explicit its functionality.
Table 41.
ACTUATOR
MODEL
XTE
XTE
EFS
EFS
The ESD input mode parameter can be set on "Actuator Setup" menu of local control or AManager
software (see Figure below).
Figure 21
Addendum for Base Card FW 7.00
ESD INPUT MODE ESD COMMAND (CH 53)
PARAMETER FUNCTIONALITY
PST-efs Electrical ESD
EFS Electrical ESD
PST-efs PST
EFS Spring ESD
Section 9: Addendum for Base Card FW 7.00
ESD STATUS (CH 18)
FUNCTIONALITY
ESD IN PROGRESS
ESD IN PROGRESS
PST IN PROGRESS
ESD IN PROGRESS
January 2022
59