Adjust Side Guidance - Weber Geset 111 Original User Manual

Chapter 7 Adjustment and initial operation

Adjust side guidance

The side guidances are used to determine the place at the conveyor where the product to
be labeled should be transported to.
Information on adjustment of side guidance
The side guidances are adjusted by the clamping pieces. The guidances have to be
adjusted that between product and side guiding is a crack of appr. 1-1,5 mm per side.
No.
1
2
3
Requirements
¥
Labeling system is turned off.
¥
2 sample products.
¥
No transportation of products.
Instruction
Please adjust the side guidance as follows.
Step
1
2
3
4
5
Version: 12.05.14
Description
SIDE GUIDANCE
CLAMPING PIECE FOR SIDE GUIDANCE
DISTANCE = PRODUCT + 2-3 mm
Procedure
Loosen the clamping pieces.
Open the side guidances and place one sample product at beginning and
end.
Adjust the side guidance to the required criteria (s. section above). Observe
a distance of 1 - 1,5 mm to the product. (In infeed passage this distance can
be adjusted larger.)
Tigthen the clamping pieces.
Check the adjustment by moving a sample product through the side
guidances. The sample product has to slide easily through the guidance at
each passage.
Page 34 of 56
40001684 Geset 111
Fig. 7-2: Side guidance
GB