Table of Contents
Advertisement
Chapter 2 Safety regulations
Warnings on the labeling system
Special hazards arising from the labeling system are identified with yellow stickers. The
pictograms indicate hazards:
Remaining risks
The labeler is constructed in a way that makes it safe for use. Some hazards are inherent
in the design and construction but can be minimized with the corresponding safety
mechanisms and equipment. A certain residual risk always exists when operating
machinery. Knowledge about residual risks of the system helps you to increase your
safety awareness and avoid accidents. To prevent hazards, observe the special safety
instructions and each chapter. When connecting the labeler to the customer's conveying
system, there may arise hazard areas at the transitions. Suitable protection measures
have to be arranged in this case.
Version: 12.05.14
Danger of injury from corners and edges.
RISK OF INJURY!
Scrapes and cuts can result from sharp edges and pointed
corners. Always keep the work area clean. The label web forms
sharp edges.
Observe caution when working close to sharp edges and
pointed corners. Remove unnecessary objects.
- In case of doubt, wear protective gloves.
- Be careful when inserting and exchanging the label web.
*² Risk of injury due to light beam.
RISK OF INJURY!
*²Sensors or *²camera illumination may have a strong light
intensity.
- Do not look into the source of light.
Life-threatening hazard due to electrical power
Crushing hazard
Entanglement hazard
*²
Danger due to strong light radiation
Observe manual
Page 16 of 56
40001684 Geset 111
*².Only if system has the appropriate features
*² Only if system has the appropriate features
GB
Advertisement
Table of Contents
