Yamaha MBK X-MAX 300 2017 Service Manual page 45

1. Fuel tank cap lid lock cable
2. ISC (Idle Speed Control) unit coupler
3. Coolant temperature sensor coupler
4. Throttle body sensor assembly coupler
5. Seat lock cable
6. AC magneto lead
7. Starter motor lead
8. Engine ground lead
9. Crankshaft position sensor coupler
10. Stator coil coupler
11. O sensor coupler
2
12. Fuel injector coupler
13. Spark plug lead
14. Wire harness
A. Route the wire harness under the fuel hose.
B. Route the wire harness under the engine ground
lead and over the AC magneto lead.
C. Make sure that the engine ground lead terminal
contacts the stopper on the crankcase.
D. Route the wire harness and rear wheel sensor
lead through the guide.
E. Route the seat lock cable through the guide.
F. Route the rear wheel sensor lead to the rear of
wire harness.
G. When routing the spark plug lead, make sure that
the distance between the lead and the frame is 5
mm (0.20 in) or more.
H. Route the AC magneto lead over the starter motor
lead.
I. Route the AC magneto lead between the starter
motor and the right crankcase.
J. Insert the projection on the wire harness holder
into the hole in the frame.
2-22
CABLE ROUTING