Yamaha MBK X-MAX 300 2017 Service Manual page 43

1. Throttle cable (decelerator cable)
2. Throttle cable (accelerator cable)
3. Seat lock cable
4. Starter motor lead
5. Wire harness
6. Smart key unit
7. Rear wheel sensor lead
8. Ignition coil
9. Frame ground
10. Sidestand switch
11. Sidestand switch lead
12. AC magneto lead
A. Route the wire harness through the guide on the
frame.
B. Route the seat lock cable to the inside of the
frame.
C. Make sure that the frame ground terminal contact
the frame.
D. Fasten the wire harness with the plastic band.
Route the plastic band through the upper hole of
the stay on the flame.
E. Point the end of plastic band downward. Make sure
that the end does not contact the fuel tank.
F. Connect the wire harness to the ignition coil as
shown in the illustration.
2-20
CABLE ROUTING