Hardware Connections For A Mobile Remote; Figure 27. Iconnex E800 Hardware Connections Diagram - iDirect Evolution 8000 Series Installation And Safety Manual

Hardware Connections for a Mobile Remote

6.2 Hardware Connections for a Mobile Remote
A diagram depicting the iCONNEX e800 hardware connections is shown in
The diagram illustrates the connections needed from GPS receiver and the Handshake device
to the e800 iCONNEX HD-15 GPIO port. The signals shown in the figure have the following
meaning:
• MUTE = 1 the transmitter is muted
• TDM_LOCK_n = 0 when the receiver is locked
• GPS-DATA is the data from the GPS receiver
The RJ-45 console port does not support GPS data input or antenna control handshaking
signals. These signals are supported by the HD-15 GPIO port.
54

Figure 27. iCONNEX e800 Hardware Connections Diagram

= 0 the transmitter is enabled
= 1 when the reciver is unlocked
iDirect Evolution 8000 Series Satellite Router Installation and Safety Manual
Figure 27.