Led Status And Definitions; Front Edge Status Leds; Table 23. Front Panel Leds - iDirect Evolution 8000 Series Installation And Safety Manual

LED Status and Definitions

5.5 LED Status and Definitions
The iCONNEX e800 Satellite Router has ten LEDs to indicate status. There are three LEDs on
the rear edge (the edge with the RJ-45 and F-connectors) and seven LEDs on the front edge
(the edge with LEDs only). Refer to
designations.

5.5.1 Front Edge Status LEDs

There are seven front panel LEDs to indicate the status of the iCONNEX e800 Satellite Router.
A description of each front panel LED is listed in

Table 23. Front Panel LEDs

LED INDICATOR
DS2 POWER
DS3 STATUS
DS4 NET
DS6 Tx
DS7 Rx
DS8 CRYPTO
DS10 TEMP
50
Figure 20 on page 44
COLOR DESCRIPTION
Off DC power is absent or there is an on-board power
regulator problem.
The internal power regulator is powered on; boot
Solid Green
loader has started.
Flashing Green Indicates initial bootup sequence; DRAM test is in
progress.
Solid Green The DRAM test passes and operation is normal.
Red Indicates a serious fault or failure within the software,
hardware, or configuration. May indicate that the
DRAM test has failed.
Flashing Yellow Indicates that the hub downstream carrier has not
been acquired.
Indicates that the hub downstream carrier has been
Solid Yellow
acquired.
Flashing Green Downstream carrier is acquired and the TDMA
upstream has been acquired by the hub.
Solid Green Network has been acquired.
Solid Yellow Transmitter is disabled.
Solid Green Transmitter is enabled.
Solid Yellow Receiver is not locked to the downstream carrier.
Solid Green Receiver is locked to the downstream carrier.
Off FIPS is not enabled.
Solid Green FIPS is enabled.
Off Indicates normal operating temperature.
Solid Yellow Operating temperature is nearing the over
temperature threshold.
Red Operating temperature threshold has been exceeded.
iDirect Evolution 8000 Series Satellite Router Installation and Safety Manual
for both front and rear edge LED
Table 23.