Table 9. E8350 Satellite Router Connectors; Table 10. Rj-45 Pin Assignments - iDirect Evolution 8000 Series Installation And Safety Manual

A description of each connector and indicator is shown in

Table 9. e8350 Satellite Router Connectors

Label
10 MHz
TX Out
RS-232
RX Out
RX In
USB
CONSOLE
LAN A
LAN B
100-240 V~
4A/2A
50/60 Hz
The RJ-45 Console port pin assignments are listed in

Table 10. RJ-45 Pin Assignments

PIN
1
2
3
4
5
iDirect Evolution 8000 Series Satellite Router Installation and Safety Manual
Connector Type
75 ohm, BNC
75 ohm, F-Type
HD-15 Female
75 ohm, F-Type with
DC Blocked
Termination
75 ohm, F-Type
USB
RJ-45
RJ-45
RJ-45
IEC-320-C14
SIGNAL NAME
Not Connected
Reserved (Tx)
Transmit Data (TxD)
Ground (GND)
Ground (GND)
Defining the e8350 Satellite Router Rear Panel
Table
Interface and Purpose
External 10 MHz clock
L-band transmit signal to Block Up Converter
(BUC) capable of 10 MHz reference and +24
VDC, 3.5A (or +48 VDC, 3A) maximum power
supply to BUC
Serial interface connection used for antenna
pointing
Monitoring of the receive signal from LNB
output, -10 dB nominal composite, buffered
L-band receive signal, capable of 10 MHz
reference and DC power to LNB
Universal Serial Bus interface connection
RS-232 servicing serial connection console to
PC or laptop
Category-5 STP or UTP cable, 10/100
Base-T Ethernet LAN port connects the e8350
and e800 iCONNEX Satellite Router models to
the customer LAN hub/switch
Category-5 STP or UTP cable, 10/100
Base-T Ethernet LAN port connects the e8350
and e800 iCONNEX Satellite Router models to
the customer LAN hub/switch
AC input
Table 10.
DESCRIPTION
Do not connect
Do not connect
RS-232 voltage level compliant transmit data
signal for debug use only
Ground
Ground
9.
23