Figure 11. Cutting Technique For Removing Foil In The Braid; Figure 12. Folding The Braid - iDirect Evolution 8000 Series Installation And Safety Manual

4. Fold the braid back over the jacket and trim the braid to the length as defined in Length
C in Table 12
5. Flare the inner, outer braids and the outer foil shield only. Do not flare the inner foil
shield (last foil around dielectric).
6. (If using a coax stripper, skip this step.) Being careful not to cut into the copper of the
center conductor, remove the foil and cut the white color inner dielectric insulation to
the length shown under Length B in
on page
7. If the conductive foil is burred, then smooth out the burr so that the edge (area where the
dielectric material was removed) is smooth and provides a lead-in for the connector
mandrel.
8. Install connector barrel over the foil and underneath the braid.
Note: The white color inner dielectric insulation should be flush with the inner rear
surface of the connector. Refer to the picture on the right in
30 for an RG-11 termination.
iDirect Evolution 8000 Series Satellite Router Installation and Safety Manual

Figure 11. Cutting Technique for Removing Foil in the Braid

and shown in Figure

Figure 12. Folding the Braid

30).
12.
Table 12. Remove any residue (as shown in
Preparing the Coax Cables
Figure 13
Figure 13 on page
29