Front And Rear Panel Led Status Definitions; Table 16. Front Panel Led Indicators - iDirect Evolution 8000 Series Installation And Safety Manual

Monitoring LED Status Indicators

4.7.2 Front and Rear Panel LED Status Definitions

The e8350 Satellite Router rear panel status LEDs are defined in

Table 16. Front Panel LED Indicators

LED Label
POWER
NET
STATUS
TX
RX
CRYPTO
FAN
TEMP
38
LED Color
Off
Green
Green
Flashing Green
Yellow
Flashing Yellow
Green
Flashing Green
Red
Green
Yellow
Green
Yellow
Green
Off
Off
Red
Yellow
Red
iDirect Evolution 8000 Series Satellite Router Installation and Safety Manual
Status
Indicates that AC powered is off or that there
is a power supply problem.
Indicates that power is on. The bootloader has
started.
Indicates that the remotes have been
acquired into the network.
Indicates that the elements are in network
acquisition.
Indicates that the downstream SCPC is locked.
Indicates that the downstream SCPC is not
locked.
Indicates normal operation. The DRAM test is
successful.
Indicates that the unit is booting. The DRAM
test is in progress.
Indicates a serious fault or failure in software,
hardware, or configuration. May indicate that
the DRAM test failed.
Indicates that the transmitter is enabled.
Indicates that the transmitter is disabled.
Indicates that the receiver is successfully
locked to the downstream.
Indicates that the demodulator is not locked
to the downstream carrier.
FIPS mode is enabled.
FIPS mode is not enabled.
No fan alarm detected.
Fan alarm detected.
Operating temperature is nearing over
temperature threshold.
Operating temperature threshold has been
exceeded.
Table 16.