Can Basic Elgo - (Option Cn0) - ELGO Electronic EMAX2 Series Operation Manual

6.3.6

CAN BASIC ELGO - (Option CN0)

Interface / Protocol:
On request the EMAX2 measuring system is equipped with a CAN interface with ELGO CAN standard
protocol.
The following identifiers are given:
80 (16) + EMAX address
10 (16) + position of decoding switch
device (4 byte telegram)
4Byte acknowledgement telegram
Status:
X = 0 without error
X = 1 error magnetic tape
The address can be adjusted in the range
of 0 to F by a decoding switch,
(16) (16)
which is located behind a protection cap
on the top of the sensor housing
LED Terminating
impedance
19
Installation / Commissioning
= Identifier to request the absolute position
= Identifier contains absolute position of the
EMAX2 (resolution 0.01 mm)
The bit rate can be adjusted by a decoding switch,
which is located behind a protection cap on the top
of the sensor housing
Address Baud rate
Position Bit rate
0 500 kBit/s
1 250 kBit/s
2 125 kBit/s