Delta Electronics Elevator Drive VFD-VL User Manual page 78

00-04 Content of Multi-Function Display
20
21
23
24 Output AC voltage when malfunction (8)
25 Output DC voltage when malfunction (8.)
26 Output frequency when malfunction (h)
27 Output current when malfunction (4)
28 Output frequency command when malfunction (h.)
It is used to display the content when LED U is ON. It is helpful for getting the AC motor drive's
status by this parameter.
Terminal MI8
Status 0
0: OFF, 1: ON
MI1: Pr.02-01 is set to 1 (multi-step speed command 1)
MI8: Pr.02-08 is set to 8 (the 1st, 2nd acceleration/deceleration time selection)
If REV, MI1 and MI8 are ON, the value is 0000 0000 1000 0110
At the meanwhile, if Pr.00-04 is set to "14" or "17", it will display "0086" with LED U is ON on
the keypad KPVL-CC01. The setting 14 is the status of digital input and the setting 17 is the
corresponding CPU pin status of digital input. User can set to 14 to monitor digital input status
and then set to 17 to check if the wire is normal.
Terminal MO10 MO9 MO8 MO7 MO6 MO5 MO4 MO3 MO2 MO1 MRA
Status
0
Revision Nov. 2008, VLE1, SW V1.03
The corresponding CPU pin status of digital output
(o.)
|
Reserved
U:
SE
MI7 MI6 MI5
0 1
U:
SE
0 0 0
D I E O N/ O FF S E t a t
E EE E EE 0 0 8 6 E E E E
MI4 MI3
0 0 0
D OE O N/ O FF S E t a t
E EE E EE 0 0 0 1 E E E E
1 0 0 0
Chapter 4 Parameters|
U: D OE P i n
SE E EE E EE
U: E r r o r E
SE E EE E EE
U: E r r o r E
SE E EE E E2
U: E r r o r E
SE E EE E EE
U: E r r o r E
SE E EE E EE
U: E r r o r E
SE E EE E EE
MI2 MI1 REV
0 1 1
in binary and 0086H in HEX.
2
0 1 1
E St t a u s E
F FF F E E E E
V o u t E EE E
E 0 . 0 V c a E
V b u s E EE E
5 6 . 4 V c d E
F o u t E EE E
0 . 0 0 z H E E
C u r e r n t E
0 . 0 0 A m s p
F c m d E EE E
0 . 0 0 A m s p
FWD
0
RA MO10
0 0
4-23