How To Use By Front Panel - Agilent Technologies TwisTorr 305 FS User Manual

Technical Information

How to Use by Front Panel

Figure 57
Start Stop and Reset Fail button

Press once for the START command and again for the STOP command. In the
case of controller's failure, press once to reset the fail condition.
The front panel START/STOP function is available only if the controller is set to
NOTE
"FRONT mode". If it is set to "REMOTE mode", when the key is pressed an error
message is shown indicating "COMMAND LOCKED IN REMOTE", if it is set to "SERIAL"
mode, the "COMMAND LOCKED IN SERIAL MODE" error message is displayed. The
"Reset Fail" function is always available regardless of controller mode.
Low Speed

Press once to activate the LOW SPEED command; press again to de-activate.
The front panel LOW SPEED function is available only if the controller is set to
NOTE
"FRONT"; otherwise an error message is returned. If it is set to "REMOTE" mode,
the COMMAND LOCKED IN REMOTE error message is displayed while if it is in
"SERIAL" mode the "COMMAND LOCKED IN SERIAL MODE" error message is
returned.
218 Agilent TwisTorr 305 FS Remote Controller User Manual