Install The Ms Covers; Install The Front Cover - Agilent Technologies G7050A Installation And Setup Manual

Install the MS Covers

Install the Front Cover

1 Place the previously removed sheet metal baffle over the e-module.
2 Place the LED cable into the plastic holder if installed.
Figure 19.
3 Secure the sheet metal baffle using the one or two previously removed T-20 screws.
Figure 20.
4 If your MS model has a LED, plug its cable into the Front Bottom Cover.
16
Putting the LED cable into the plastic holder
Secure the baffle using the previously removed screws
G7050A - Reference Compound Introduction Valve