Error Messages - Agilent Technologies TwisTorr 305 FS User Manual

Technical Information

Error Messages

For a certain type of failure, the controller will self-diagnose the error and the
following messages will be displayed.
NOTE
If the pump is not connected, the display will be as shown in the following figure.
C
Check connection between controller and pump, then press STOP push-button
twice to start the pump.
If the P1 input connector is not in position with the link or the external interlock
NOTE
connections are open, when the START pushbutton is pressed the display will be
as shown in the following figure.
Disconnect connector P1 and check the link or the external interlock, then install the
connector to start the pump.
If within each step of the soft start mode the rotational speed of the pump do not
NOTE
reach the planned value within 15 minutes the display will be as shown in the
following figure.
Agilent TwisTorr 305 FS Remote Controller User Manual
H E C K
T O
W
I N
C O N N E
P U M P
A I T I N
T E R L O
C T I O N
G
C K
257