Set-Up - Agilent Technologies TwisTorr 305 FS User Manual

Instructions for Use

Set-up

The controller is designed for indoor use only and must be powered with
WARNING
3-wire power cord (see orderable parts table) and plug (internationally
approved) for user's safety. Use this power cord and plug in conjunction
with a properly grounded power socket to avoid electrical shock and to
satisfy CE requirements. High voltage developed in the controller can
cause severe injury or death. Before servicing the unit, disconnect the
input power cable.
Power supply cord: the correct cable for electrical wiring is a three wires
WARNING
(Ph+N+Earth) cable.
The wire section has to be at least 1.0 mm
voltage or 2 mm
length equal to 3 m.
TwisTorr 305 FS Remote Controller can be used as a bench unit or a rack module,
NOTE
but it must be positioned so that free air can flow through the holes. Do not install
or use the controller in an environment exposed to atmospheric agents (rain,
snow, ice), dust, aggressive gases, or in explosive environments or those with a
high fire risk.
During operation, the following environmental conditions must be respected:
temperature: from +5 °C to +45 °C

relative humidity: 0 – 95 % (non-condensing).

See the appendix "Technical Information" for detailed Information about the above
mentioned and the other connections, and about the options installation.
Agilent TwisTorr 305 FS Remote Controller User Manual
2 in case of 120 Vac supply voltage for a reference cable
2 in case of 240 Vac supply
163