Table of Contents
Advertisement
4 MILLING UNIT
4.4 Turning off the milling unit
4.5 Relocating the milling unit
6
Planmeca PlanMill 40 S
1.
Touch the X in the corner of the main screen to Exit.
A verification screen appears.
2.
Touch OK to turn OFF the milling unit. Touch Cancel
to leave it ON.
The desktop for the operating system appears.
3.
Touch Start.
4.
Select Shut Down.
WARNING
The milling unit weighs approximately 77 kg (170 lb.).
Always follow these guidelines when relocating the
machine.
Be certain to drain the milling unit's fluid reservoir before
moving the unit.
The milling unit is designed to operate on a level and
stable surface in an environment free from excessive
moisture or dust. The milling unit should be located away
from the patient access area. When choosing a location
for the milling unit, adhere to all clearance requirements
stated in section 11 "TECHNICAL SPECIFICATIONS" on
page 22.
1.
Ensure no milling operations are in progress.
2.
Open the front access panel and remove the fluid
reservoir.
3.
Empty the fluid reservoir according to your approved
material disposal protocols.
4.
Turn OFF the milling unit.
5.
Disconnect all power and data connections.
User's manual
Advertisement
Table of Contents
