Composite Block Defoaming Solution; Zirlux Fc2 Scale Factor - Planmeca PlanMill 40 S User Manual

8 OPERATING THE MILLING UNIT

8.3 Composite block defoaming solution

8.4 Zirlux FC2 scale factor

14 Planmeca PlanMill 40 S
Insert the block into the correct position and lock the block
in place by tightening the cam.
Composite Block Defoaming Solution is used with
Paradigm blocks. Due to the nature of the composite
material when milled, it is necessary to use this solution
every time you mill with the MZ100 block. Without the
defoaming solution, the milling fluid may foam and
overflow.
1. After inserting the Ivoclar Vivadent Telio CAD block
into the milling chamber, shake the bottle of
defoaming solution and position it over the chamber.
2. Press down once to release the solution directly into
the milling chamber.
3. Close the chamber and begin the milling process as
explained below.
See the manufacturer's Instructions for Use provided with
the Zirlux FC2 blocks for processing instructions.
Zirconia shrinks in the sintering oven. There are numbers
on the side of the box that the blocks come in. You must
keep this box with the blocks. Do not mix blocks from
different boxes. Each box can have a different amount of
shrinking. The milling unit asks for the Scale Factor before
a Zirlux FC2 is milled. The system will increase the size of
the restoration according to this number. This means you
cannot test the fit of the restoration before sintering.
NOTE
It is necessary to clean the milling unit and change the
water before milling Zirlux FC2. If the zirconia is
contaminated with other materials, it will turn green when
sintered. Cleaning after milling is recommended because
the zirconia acts as a thickening agent with the water.
User's manual