Planmeca PlanMill 40 S User Manual page 14

5 FOR YOUR SAFETY
10 Planmeca PlanMill 40 S
Do not make any unauthorized repairs or modifications to
the system software or hardware. This includes installing
unauthorized software on the computer system or altering
or bypassing any safety switches or mechanisms.
Do not install or operate the products in an environment
where an explosion hazard exists, e.g., high oxygen area.
Comply with all applicable regulations when disposing of
waste materials.
Do not attach any equipment or devices to the products
unless their use has been specifically authorized by or
Planmeca or E4D Technologies.
The wireless components in the products may be
interfered with by other equipment, even if the other
equipment is fully compliant with CISPR (International
Special Committee on Radio Interference) emission
requirements.
When possible, electrical equipment should not be used
when adjacent to other electrical equipment. If adjacent
use is necessary, the equipment should be observed to
verify normal operation in the configuration in which it will
be used.
When connecting the components, use only the cables
supplied with the products. Failure to do so may result in
increased electromagnetic emissions or reduced
immunity to external electromagnetic emissions.
Ensure your products are properly maintained through
periodic maintenance.
If you suspect equipment malfunction or failure,
discontinue using the products and contact Planmeca
Technical Support immediately. Do not attempt to make
any repairs on the products.
Read and comply with all safety, warning, and
instructional labels on the products.
User's manual