Table of Contents
Advertisement
Type 8650 REV.2
Initial start-up and project planning
17
INITIAL START-UP AND PROjECT PLANNING
17.1
Safety instructions
Danger
Risk of injury due to high pressure and escaping medium.
▶ Switch off the pressure before working on the device or system. Vent or empty the lines.
Risk of injury from electric shock.
▶ Switch off the power supply before working on the device or system. Secure it against reactivation.
▶ Observe any applicable accident prevention and safety regulations for electrical devices.
Valves and electronic modules can be replaced under voltage.
Warning
Risk of injury due to improper operation.
Improper operation may result in injuries as well as damage to the device and the surrounding area.
▶ Before start-up, ensure that the operating personnel are aware of and have completely understood the
contents of the operating instructions.
▶ Observe the safety instructions and information on intended use.
▶ Only adequately trained specialists are allowed to put the device into operation.
Risk of injury due to system malfunction.
The system must be tested to ensure it functions properly before start-up. This prevents persons or
systems from being put in danger during operation.
▶ Conduct a full function test and the necessary safety tests before the initial start-up.
▶ Plan foreseeable errors in the tests.
note
Only provide the device with electricity via sImaTIc ET 200isp
▶ In order to prevent damage to the device, the device must solely obtain its power supply via the Power-
Supply module of the ET 200iSP.
preventing pressure drop
▶ To avoid a pressure drop, provide the device's pressure supply to the greatest extent possible.
Electrostatically sensitive components and assemblies
The device contains electronic components that are susceptible to the effects of electrostatic discharging
(ESD). Components that come into contact with electrostatically charged persons or objects are at risk. In
the worst case scenario, these components will be destroyed immediately or fail after start-up.
▶ Meet the requirements specified by EN 61340-5-1 to minimise or avoid the possibility of damage
caused by a sudden electrostatic discharge.
▶ Do not touch electronic components when the supply voltage is connected.
English
83
Advertisement
Table of Contents
