Lithium Battery; Cpu; System Ram; Compatible Memory Modules - VersaLogic Python EBX-11 Reference Manual

Amd lx 800 based sbc with ethernet, video, audio, industrial i/o, and spi
Table of Contents

Advertisement

The exact power requirement of the EBX-11 depends on several factors, including memory
configuration, CPU speed, peripheral connections, type and number of expansion modules and
attached devices. For example, PS/2 keyboards typically draw their power directly from the
EBX-11, and driving long RS-232 lines at high speed can increase power demand.
L
B
ITHIUM
ATTERY
Warning!
To prevent shorting, premature failure or damage to the lithium battery, do not
place the board on a conductive surface such as metal, black conductive foam or
the outside surface of a metalized ESD protective pouch. The lithium battery may
explode if mistreated. Do not recharge, disassemble or dispose of in fire. Dispose
of used batteries promptly.
Nominal battery voltage is 3.0V. If the voltage drops below 2.7V, contact the factory for a
replacement (part number HB3/0-1). The life expectancy under normal use is approximately 10
years.

CPU

The Geode LX 800 microcontroller has a 32-bit, low-voltage AMD x86 microprocessor at its
core. The maximum clock rate is 500 MHz actual, with 800 MHz (Celeron equivalent)
performance. The LX 800 features 64 kb of L1 cache, 128 kb of L2 cache, DDR SDRAM
support, and an integrated display controller. The CPU operates without a heat sink and has a
typical power consumption of 1.6W.

System RAM

C
M
OMPATIBLE
EMORY
The EBX-11 accepts one 200-pin SODIMM memory module with the following characteristics:
Size
Voltage
Type
Note
CMOS settings default to DDR 333 MHz. Settings to DDR 400 MHz are available,
but VersaLogic only guarantees operation at the default settings.

CMOS RAM

C
CMOS RAM
LEARING
A jumper may be installed into V3[2-3] to erase the contents of the CMOS RAM and the Real-
Time Clock. When clearing CMOS RAM: 1) Power off the EBX-11. 2) Remove the jumper from
V3[1-2], install it on V3[2-3] and leave it for four seconds. 3) Move the jumper to back to
V3[1-2]. 4) Power on the EBX-11.
EBX-11 Reference Manual
M
ODULES
Up to 1GB
2.5V
PC2700 compatible (DDR 333 MHz)
System Features
23

Advertisement

Table of Contents
loading

Table of Contents