VersaLogic Python EBX-11 Reference Manual page 15


If you are using a PS/2 keyboard or mouse, plug the breakout cable CBR-5009A into
socket J4. If necessary, attach the breakout board CBR-5009B to the cable. (The cable
and board are shipped attached.) Plug the keyboard and/or mouse into connector J4 of
breakout board.

If you are using a USB keyboard or mouse, plug them into socket J20 or J21 of the
EBX-11.

Plug the hard drive data cable CBR-4404 into socket J12. Attach a hard drive and CD-
ROM drive to the connectors on the cable. If the hard drive is 3.5", use the 2mm to 0.1"
adapter CBR-4405 to attach the IDE cable.
 Attach an ATX power cable to any 3.5" drive (hard drive or CD-ROM drive).

Set the hard drive jumper for master device operation and the CD-ROM drive jumper for
slave device operation.
4. Review Configuration

Before you power up the system, double check all the connections. Make sure all cables
are oriented correctly and that adequate power will be supplied to the EBX-11 and
peripheral devices.
5. Power On

Turn on the ATX power supply and the video monitor. If the system is correctly
configured, a video signal should be present.
6. Change CMOS Setup Settings

Enter CMOS Setup by pressing Delete during the early boot cycle.

Select Basic Configuration and set or verify the following settings (see CMOS Setup for
a complete list of default settings):
DRIVE ASSIGNMENT ORDER | Drive C: Ide 0/Pri Master
ATA DRV ASSIGNMENT | Ide 0: 3 = AUTOCONFIG, LBA
ATA DRV ASSIGNMENT | Ide 1: 5 = IDE CDROM
BOOT ORDER | Boot 1st: CDROM
BOOT ORDER | Boot 2nd: Drive C:

Before saving the CMOS Setup settings, insert the Windows (or other OS) installation
disk in the CD-ROM drive so it will be accessed when the system reboots.

Press ESC and write the new parameters to CMOS RAM. The system will reboot.
7. Install Operating System

Install the operating system according to the instructions provided by the OS
manufacturer. (See Operating System Installation.)
Note
If you intend to operate the EBX-11 under Windows XP or Windows XP
Embedded, be sure to use Service Pack 2 (SP2) for full support of the latest
CS5536 I/O hub and its USB 2.0 features.
EBX-11 Reference Manual
Configuration and Setup
9