Crankcase Cover Removal/Installation - Honda GP200H Manual

CRANKCASE COVER
REMOVAL/INSTALLATION
Drain the engine oil (page 3-4).
DOWEL PIN (2)
OIL FILLER CAP
(With oil level gauge)
OIL FILLER CAP PACKING
CHECK:
Replace if necessary.
CRANKSHAFT BEARING (6205)
CRANKCASE COVER
INSTALLATION:
Be careful not to damage the oil seal lips.
Clean the mating surface and apply a bead (2.0 – 2.5 mm (0.08 – 0.10 in))
of liquid sealant (ThreeBond ®
Install the cover within 3 minutes after application. Pouring the engine oil is
performed after 30 minutes have elapsed from assembling.
CYLINDER BLOCK
OIL FILLER CAP
OIL FILLER CAP
PACKING
CHECK:
Replace if necessary.
OIL SEAL
CRANKCASE COVER BOLT (8 x 32 mm) (6)
24 N·m (2.4 kgf·m, 18 lbf·ft)
1216E, 1207B, or equivalent) as shown.
(Lips)
13-3