Transmission Oil Level Check; Transmission Oil Change - Honda GP200H Manual

MAINTENANCE

TRANSMISSION OIL LEVEL CHECK

• Check the transmission oil level with the engine
stopped.
Place the tiller on a firm level surface with the tire or
rotor set on the ground so that the engine becomes
level.
Remove the oil filler cap [1] and check the oil level is up
to the lower edge [2] of the oil filler hole.
If the level is low, fill with the recommended
transmission oil to the upper level (up to the lower edge
of the oil filler hole).
RECOMMENDED TRANSMISSION OIL:
SAE 10W-30
API service classification SE or higher
Check that the O-ring [3] is in good condition, replace it
if necessary.
Apply transmission oil to the O-ring.
Reinstall and tighten the oil filler cap securely.

TRANSMISSION OIL CHANGE

Place a suitable container [1] under the drain plug bolt
[2].
Remove the oil filler cap (page 3-10).
Remove the drain bolt, drain plug washer [3] and drain
the transmission oil into the suitable container.
Please dispose of used transmission oil in a manner
that is compatible with the environment. We suggest
you take used oil in a sealed container to your local
recycling center or service station for reclamation. Do
not throw it in the trash, pour it on the ground, or down a
drain.
Used transmission oil contains substances that
have been identified as carcinogenic.
If repeatedly left in contact with the skin for
prolonged periods, it may cause skin cancer.
Wash your hands thoroughly with soap and water
as soon as possible after contact with used
transmission oil.
Install the drain plug bolt and new drain plug washer.
With the tiller on a level surface, fill the recommended
transmission oil (page 15-15).
TRANSMISSION OIL CAPACITY:
1.2 liters (1.3 US qt, 1.1 lmp qt)
Recheck the transmission oil level (page 3-10).
Make sure there are no transmission oil leaks.
3-10
[3]
[2]
[1]
[2]
[3] [1]