Honda GP200H Manual page 108

HANDLE COLUMN
DISASSEMBLY/ASSEMBLY
Remove the following:
– Handle column assembly (page 14-2)
– Engine stop switch (page 7-8)
– Clutch lever (page 14-4)
– Throttle lever (page 14-5)
HANDLE ADJUSTING LEVER
GROMMET
HANDLE COLUMN COVER
BOLT (5 x 8 mm)
1.25 N·m (0.13 kgf·m, 0.9 lbf·ft)
HANDLE COLUMN COVER
CABLE GUIDE
CHANGE COVER
HANDLE COLUMN
When reassembly,
apply grease to the
sliding surface.
RETURN SPRING
BOLT (6 x 12 mm)
CHANGE LEVER HOLDER
REASSEMBLY:
Install the long side against the handle column.
Apply grease to the sliding surface.
NUT
SPRING WASHER
HANDLE PIPE
HANDLE LOCK NUT
When reassembly, install the
handle lock nut tab into the
handle pipe hole.
HANDLE COLUMN COVER
SCREW (5 x 12 mm) (2)
1.25 N·m (0.13 kgf·m, 0.9 lbf·ft)
CABLE GUIDE SCREW (5 x 10 mm)
PIN
BOLT (6 x 12 mm) (2)
WASHER (6 mm)
BOLT (6 x 12 mm)
WASHER (12 mm)
LOCK PIN (12 mm)
HANDLE
CHANGE LEVER
GRIP
When reassembly, apply
ThreeBond ® 1530C or
equivalent to the inside.
UPPER CHANGE LEVER
LOCK PIN
LOWER CHANGE LEVER
14-3