Honda GP200H Manual page 52

CHOKE REPLACEMENT
Remove the carburetor (page 5-5).
Pull out the choke valve plate [1].
Remove the choke shaft [2] and install a new choke
shaft.
Insert a new choke valve plate into the slit [3] of the
choke shaft.
Be sure the choke shaft is in the position between the
projections [4] of the choke valve plate.
CARBURETOR STUD BOLT
REPLACEMENT
Remove the carburetor (page 5-5).
Thread two nuts onto the carburetor stud bolts [1] and
tighten them together, then use a wrench to turn the
stud bolt out.
Install and tighten new stud bolts until they are fully
seated.
FUEL SYSTEM
[2]
[2]
[4]
[1]
[1]
[3]
[1]
[4] [2]
5-9