Honda GP200H Manual page 73

STARTING SYSTEM
Apply grease to the two starter ratchets [1].
Install the two starter ratchets and the two return
springs [2] to the recoil starter reel as shown.
Apply grease to the inside of the ratchet guide [1].
Set the friction spring [2] and the ratchet guide to the
recoil starter reel in the direction as shown.
Apply locking agent (LOCTITE
the threads of the set screw [3].
Hold the ratchet guide and tighten the set screw to the
specified torque.
TORQUE: 8.8 N·m (0.90 kgf·m, 6.5 lbf·ft)
Turn the recoil starter reel [1] more than 2 turns
counterclockwise to preload the recoil starter spring. Be
sure to hold the recoil starter reel.
Pass the recoil starter rope through hole [1] of the recoil
starter case, the starter knob [2], and then tie the rope
as shown.
Check the recoil starter operation (page 8-2).
8-6
262 or equivalent) to
®
[1]
[1]
[1]
[1]
[2]
[3]
[2]
[2]
15 – 25 mm
(0.6 – 1.0 in)