Honda GP200H Manual page 48

CARBURETOR
REMOVAL/INSTALLATION
Gasoline is highly flammable and explosive. You
can be burned or seriously injured when handling
fuel.
• Keep heat, sparks, and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
Remove the air cleaner elbow (page 5-4).
Set a commercially available tube clamp to the fuel
tube.
Drain the fuel completely (page 5-3).
FUEL TUBE
TUBE CLIP
INSULATOR
PACKING
CARBURETOR INSULATOR
INSTALLATION:
Before installing, clean the passage [1] thoroughly
with compressed air.
Install the carburetor insulator with the vent groove
facing toward the carburetor.
After installing, clamp the high-tension cord [2], the
engine wire harness [3] and fuel tube [4] to the
carburetor insulator.
[2]
[3]
[1]
[4]
GOVERNOR ROD/THROTTLE RETURN SPRING
REMOVAL/INSTALLATION:
Pull the carburetor to a point where the groove [1] of
the throttle arm lines up with the governor rod [2],
and then lift the governor rod out of the hole of the
throttle arm and unhook the throttle return spring [3].
[2]
[3]
TUBE
CLAMP
CARBURETOR PACKING
CARBURETOR
FUEL SYSTEM
[1]
5-5