Honda GP200H Manual page 55

GOVERNOR SYSTEM
CONTROL BASE/GOVERNOR ARM
GOVERNOR SYSTEM
REMOVAL/INSTALLATION
Remove the fuel tank (page 5-3).
Remove the air cleaner elbow (page 5-4).
Disconnect the throttle cable (page 10-2).
After installation,
ADJUSTMENT" (page 6-3).
GOVERNOR ROD/THROTTLE RETURN SPRING
REMOVAL/INSTALLATION:
Pull the carburetor to a point where the groove [1] of
the throttle arm lines up with the governor rod [2],
and then lift the governor rod out of the hole of the
throttle arm and unhook the throttle return spring [3].
[2]
[3]
BOLT (6 x 12 mm) (2)
CONTROL BASE
THROTTLE CABLE
6-2
perform the "GOVERNOR
GOVERNOR SPRING
When reassembly, install the
spring with the long end side
toward the control base.
INSTALLATION:
Hook the throttle return spring
on the hole marked "H".
[1]
PINCH BOLT
GOVERNOR ARM
ADJUSTMENT: (page 6-3)
GOVERNOR ARM NUT (6 mm)