Honda GP200H Manual page 49

FUEL SYSTEM
CARBURETOR
DISASSEMBLY/ASSEMBLY
Gasoline is highly flammable and explosive. You
can be burned or seriously injured when handling
fuel.
• Keep heat, sparks, and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
To prevent serious eye injury, always wear safety
goggles or other eye protection when using
compressed air.
Remove the carburetor (page 5-5).
Before disassembly, clean the outside of the carburetor.
BE69G A shown:
PILOT JET SET
ASSEMBLY:
Before installing, clean
thoroughly with low-pressure
compressed air.
Lightly lubricate the O-ring [1]
to ensure easy installation
into the carburetor body.
PILOT SCREW
REPLACEMENT/
INSTALLATION: (page 5-8)
MAIN NOZZLE
UPPER
ASSEMBLY:
SIDE
Before installing, clean
thoroughly with low-
pressure compressed air.
MAIN JET
ASSEMBLY:
UPPER
Before installing, clean
SIDE
thoroughly with low-
pressure compressed
air.
FLOAT CHAMBER
ASSEMBLY:
Install the float chamber to the
carburetor body at an angle as shown.
0 – 30°
5-6
O-RING
THROTTLE STOP SCREW
[1]
ADJUSTMENT: (page 3-11)
LIMITER CAP
FLOAT
O-RING FLOAT PIN
SET BOLT GASKET
SET BOLT
LEVER SETTING PLATE
SCREW
(3 x 6 mm) (2)
CHOKE LEVER
SPRING PIN
CARBURETOR BODY
FLOAT VALVE
FLOAT VALVE SPRING
DRAIN SCREW GASKET
DRAIN SCREW
VALVE LEVER
SPRING
FUEL VALVE LEVER
FUEL VALVE
PACKING
CHECK:
Replace if necessary.