Honda GP200H Manual page 101

CYLINDER BLOCK
CONNECTING ROD SMALL END I.D.
Measure the connecting rod small end I.D.
STANDARD: 18.006 – 18.017 mm (0.7089 – 0.7093 in)
SERVICE LIMIT: 18.07 mm (0.711 in)
If the measurement is more than the service limit,
replace the connecting rod.
Inspect the piston pin O.D. (page 13-8).
CONNECTING ROD BIG END I.D.
Apply engine oil to the connecting rod bolt threads and
seating surface.
Set the connecting rod lower to the connecting rod
upper and tighten the connecting rod bolts to the
specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Measure the connecting rod big end I.D.
STANDARD: 30.015 – 30.025 mm (1.1817 – 1.1821 in)
SERVICE LIMIT: 30.066 mm (1.1837 in)
If the measurement is more than the service limit,
replace the connecting rod (page 13-5).
CRANKPIN O.D.
Measure the crankpin O.D. of the crankshaft.
STANDARD: 29.970 – 29.980 mm (1.1799 – 1.1803 in)
SERVICE LIMIT: 29.920 mm (1.1780 in)
If the measurement is less than the service limit,
replace the crankshaft.
13-10