Troubleshooting - Yamaha Tracer 9 Owner's Manual

1 1
1. Collar
2. License plate light bulb
3. License plate light unit
3. Remove the license plate light
bulb socket (together with the
bulb) by turning it counterclock-
wise, and then pulling it out.
4. Remove the burnt-out bulb by
pulling it out.
5. Insert a new bulb into the socket.
6. Install the socket (together with
the bulb) by pushing it in, and then
turning it clockwise until it stops.
7. Install the license plate unit onto
the rear fender.
8. Install the bolts and tighten to the
speci ed torque.
Tightening torque:
License plate light unit bolt:
2
4.0 N·m (0.40 kgf·m, 3.0 lb·ft)
3
Periodic maintenance and adjustment
7-33

Troubleshooting

Although Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur
during operation. Any problem in the
fuel, compression, or ignition systems,
for example, can cause poor starting
and loss of power.
The following troubleshooting charts
represent quick and easy procedures
for checking these vital systems your-
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are often
inferior, have a shorter service life and
can lead to expensive repair bills.
WARNING
When checking the fuel system, do
not smoke, and make sure there are
no open ames or sparks in the ar-
ea, including pilot lights from water
EAU25872
7
EWA15142