Yamaha Tracer 9 Owner's Manual page 41

BC
BC Setting
BC 2
The brake control system has two set-
tings, BC1 and BC2. Select BC1 when
only standard ABS is desired. Select
BC2 to have the brake control system
further regulate brake pressure while
cornering to suppress lateral wheel
slip.
TIP
For skilled riders and when riding at the
track, due to varying conditions, the
BC2 brake system may engage sooner
than expected relative to your desired
cornering speed or intended cornering
line.
QS
km/h
The quick shift system indicators are
divided into QS
QS and QS
can be independently turned on or off.
QS can be set to ON or OFF.
OFF turns the respective upshift or
downshift function off, and the clutch
lever must then be used when shifting
in that direction.
TIP
• If the QSS setting cannot be
changed: turn the engine off with
the gear position set to neutral,
then change the setting.
• If the QSS is not equipped on the
vehicle: this module is still dis-
played and can be accessed from
Instrument and control functions
QS Setting
QS ON
QS ON
km/h
and QS sections.
are not linked and
4-19
the settings MENU but it is inoper-
able and any changes cannot be
saved.
"Shift Indicator"
Shift Indicator
IND Mode ON
IND Start 8000 r/min
IND Stop 10000 r/min
This module allows a custom shift indi-
cator to be set. When the engine r/min
(rotations per minute) are in the speci-
ed range, the gear indicator will ash.
This module has 3 options:
"IND Mode" - the shift indicator can be
turned ON/OFF
"IND Start" - the r/min at which the in-
dicator starts ashing can be chosen.
Once selected, rotate the wheel switch
up/down to increase or decrease the
r/min value by increments of 200 r/min.
"IND Start" is settable between 6000 -
12800 r/min.
4
km/h