Figure 32: Front Panel Of The Power Supply Module - Mellanox Technologies Grid Director 4700 Installation Manual

Mellanox Grid Director 4700 Installation Manual
Refer to the Regulatory Compliance and Safety Reference Manual before connecting the
power supplies to mains.

Figure 32: Front Panel of the Power Supply Module


To insert a power supply unit into the chassis:
1. Carefully seat the unit into the designated slot. Slowly slide the unit into the chassis until
the unit is completely engaged on the chassis edge.
2. Tighten the screws.

To extract a power supply from the chassis:
1. Disconnect power cable.
2. Loosen the screws.
3. Extract the power supply by pulling the handles.
For Taiwan:
Please recycle batteries

Verify that you have the correct number of power supplies installed when powering up the
system. Using fewer than the required power supplies for your specific configuration can cause
malfunction.

All power supplies must be powered simultaneously. If not powered simultaneously, the system
may not start properly.
This product may contain sealed lead acid, nickel cadmium, nickel metal hydride, lithium,
or lithium ion battery. The battery must be recycled or disposed of properly. Recycling
facilities may not be available in your area. Batteries or packaging for batteries are labeled
in accordance with European Directive 2006/66/EC concerning batteries and accumulators
and waste batteries and accumulators. The Directive determines the framework for the
return and recycling of used batteries and accumulators as applicable throughout the
European Union.
71