Mellanox Grid Director 4700 Installation Manual
To install the Grounding Stud:
1. Insert a 10-32 5/8" screw through the Grounding hole, rear-to-front, as shown.
2. Add a spring washer onto the 10-32 5/8" thread, this time front-to rear.
3. Add a nut #10.
4. Add another spring washer.
5. Insert the 6 AWG grounding cable. Connect the other end of the grounding cable to a
grounding point at your site.
6. Add another spring washer. Make sure that the grounding cable is tightly secured between
the two spring washers.
7. Secure everything with a grounding nut #10.
8. Apply the Ground label under the grounding nut.
9. Apply the Safety Warning label on the side of the chassis, near the grounding stud.
51