Introduction - Quectel FG50V Hardware Design

Wi-Fi&BT Module Series
FG50V Hardware Design
1

Introduction

This document defines the FG50V module and describes its air interfaces and hardware interfaces which are
connected with your application.
This document can help you quickly understand module interface specifications, electrical and mechanical details,
as well as other related information of the module. Associated with application notes and user guides, you can use
FG50V module to design and set up applications easily.
Hereby, [Quectel Wireless Solutions Co., Ltd.] declares that the radio equipment type [FG50V] is in
compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
http://www.quectel.com.
The device could be used with a separation distance of 20cm to the human body.
FCC Certification Requirements.
According to the definition of mobile and fixed device is described in Part 2.1091(b), this device is a mobile device.
And the following conditions must be met:
1. This Modular Approval is limited to OEM installation for mobile and fixed applications only. The antenna
installation and operating configurations of this transmitter, including any applicable source-based timeaveraging
duty factor, antenna gain and cable loss must satisfy MPE categorical Exclusion Requirements of 2.1091.
2. The EUT is a mobile device; maintain at least a 20 cm separation between the EUT and the user's body and
must not transmit simultaneously with any other antenna or transmitter.
3. A label with the following statements must be attached to the host end product: This device contains FCC ID:
XMR202103FG50V
4. To comply with FCC regulations limiting both maximum RF output power and human exposure to RF radiation,
maximum antenna gain (including cable loss) must not exceed:
WIFI 2.4G/5G : 5.38 dBi
5. This module must not transmit simultaneously with any other antenna or transmitter
6. The host end product must include a user manual that clearly defines operating requirements and conditions
that must be observed to ensure compliance with current FCC RF exposure guidelines.
For portable devices, in addition to the conditions 3 through 6 described above, a separate approval is required to
satisfy the SAR requirements of FCC Part 2.1093
If the device is used for other equipment that separate approval is required for all other operating configurations,
including portable configurations with respect to 2.1093 and different antenna configurations.
For this device, OEM integrators must be provided with labeling instructions of finished products.
Please refer to KDB784748 D01 v07, section 8. Page 6/7 last two paragraphs:
FG50V_Hardware_Design 8 / 54