Table of Contents
Advertisement
RZ/N1D/S/L Group
Application Note
PROFINET Quick Start Guide
2 Features
The port GmbH's PROFINET device stack is a fully implemented Conformance Class A PROFINET stack. It
has no feature restrictions but in demonstration mode it only runs about 3 hours. Using the SNMP stack
Conformance Class B is also possible.
It contains but is not restricted to the following features:
•
Alarms
•
Diagnosis
•
Cyclic data exchange up to 1 ms cycle time (depending on the application)
•
Acyclic data
•
Unrestricted record data access (depending on the application)
•
Neighbourhood detection support
•
DCP support (station name, IP configuration, factory reset)
•
LLDP support
•
Examples with ready to run projects
•
Callbacks for various PROFINET events
•
Dynamic module plug and pull support / dynamic device configuration
•
Supported by the port GmbH PROFINET I/O Config Tool
R11QS0010ED0143 Rev.1.4.3
July 09, 2019
Preliminary document. Specifications in this
document are tentative and subject to change.
2. Features
Page 7 of 26
Advertisement
Table of Contents
