Table of Contents
Advertisement
RZ/N1D/S/L Group
Application Note
PROFINET Quick Start Guide
4. Setting up a PROFINET PLC (Tia Portal with S7-1500)
This chapter shows how to setup a PROFINET PLC by using the Siemens tool TIA ("Totally Integrated
Automation" – Version V13 SP1 Update 4). The step by step instructions are exemplarily done for the
PLC "SIMATIC 1511-1 PN".
4.1. Preparation
1. Connect the devices (RZ/N1 to PLC, PLC to PC with TIA)
2. Change the IPv4 address of the computer interface to a private network address (e.g.
192.168.0.30)
4.2. Setting up PLC
1. Open the Siemens tool TIA and create a new project
2. Switch to the "Project view"
3. Load the GSDML file (Menu Options > Manage GSD) and install it
o The GSDML file can be found in goal\protos\pnio\gsdml
4. Add the RZ/N device to the project (Figure 4-1):
o Double click on "Devices & networks"
o Open "Network view"
o Drag & drop the device "Standard" from catalogue directory (Other field devices >
PROFINET IO > Drives > I/O > port GmbH > port GmbH > port IO Examples)
o There should be 4 devices in the listing. The 2 port DAP must be used for the
standalone RZ/N1 board and the 4 port DAP for the extension board.
5. Add input and output modules to RZ/N1 (Figure 4-2):
o Change to "Device view"
o Drag & drop the modules "64 bytes I" and "64 bytes O" from hardware catalogue to the
device
R11QS0010ED0143 Rev.1.4.3
July 09, 2019
Preliminary document. Specifications in this
document are tentative and subject to change.
Figure 4-1: Add device to project
4. Setting up a PROFINET
PLC (Tia Portal with S7-
1500)
Page 19 of 26
Advertisement
Table of Contents
