Figure 4-7: Configuration Of The Connection; Figure 4-8: Finish Configuration - Renesas RZ Series Quick Start Manual

RZ/N1D/S/L Group
Application Note
PROFINET Quick Start Guide
Finish PLC configuration (Figure 4-8)
Now the PLC should connect to the device and exchange cyclic data with it. As the data is mirrored in
the 01_simple_io example the PLC can be also programmed to send cyclic over the output module
which should be mirrored on the input module.
Watching and changing the cyclic data can also be easily achieved with the port GmbH PROFINET I/O
Config Tool.
R11QS0010ED0143 Rev.1.4.3
July 09, 2019
Preliminary document. Specifications in this
document are tentative and subject to change.

Figure 4-7: Configuration of the connection

Figure 4-8: Finish configuration

4. Setting up a PROFINET
PLC (Tia Portal with S7-
1500)
Page 23 of 26