Wiznet WizFi320 User Manual page 47

WizFi320 User Manual
OEM/integrators Installation Manual
the modules limited to OEM installation only
the OEM integrator is responsible for ensuring that the end-user has no manual
instruction to remove or install module.
the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed.
Instructions to the OEM/integrator
The OEM integrator must include the instructions or statements required by part 15.19
and 15.21 in the user manual.
the OEM integrator must include a separate section in the host user's manual
concerning the operating conditions to satisfy RF exposure compliance.
there is requirement that the grantee provide guidance to the host manufacturer for
compliance with part 15b requirements.
Caution
THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY
APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE
USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
Exposure to Radio Frequency Radiation.
To comply with FCC RF exposure compliance requirements, a separation distance of at
least 20 cm must be maintained between the antenna of this device and all persons.
IMPORTANT NOTE : FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.
This deivice is intended only for OEM integrators under the following conditions:
(1) This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
(2) This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
As long as 2 conditions above are met, further transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end-product for
any additional compliance requirements with this device installed.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation. Revision 1.0 (NOV,2019) 19
This module has been granted modular approval for mobile applications. OEM
integrators for host products may use the module in their final products without
© Copyright 2021 WIZnet Co., Ltd. All rights reserved. 47