Wiznet WizFi320 User Manual page 38

The configuration changes will be saved in the NVS area
•
if AT+SYSSTORE=1.
The set command correlates with the commands that set DHCP, such
•
as AT+CWDHCP.
o
o
o
Example
AT+CIPAP="192.168.5.1","192.168.5.1","255.255.255.0"
AT+CWSTARTSMART: Start SmartConfig
Execute Command
Function:
Start SmartConfig of the type ESP-TOUCH+AirKiss.
Command:
AT+CWSTARTSMART
Set Command
Function:
Start SmartConfig of a designated type.
Command:
AT+CWSTARTSMART=<type>[,<auth floor>]
Response:
OK
Parameters
<type>:
•
o
o
o
<auth floor>: Wi-Fi authentication mode floor. ESP-AT will not connect to
•
the AP whose authmode is lower than this floor.
o
o
© Copyright 2021 WIZnet Co., Ltd. All rights reserved.
If static IP address is enabled, DHCP will be disabled;
If DHCP is enabled, static IP address will be disabled;
The last configuration overwrites the previous configuration.
1: ESP-TOUCH
2: AirKiss
3: ESP-TOUCH+AirKiss
0: OPEN (Default)
1: WEP
WizFi320 User Manual
38